Engravers Network-CorelDRAW X3 - New Artwork in CorelDRAW 13

Phone 866-727-7256
817-261-7256
FAX 800-210-4461

Your Site For Laser & Engraving Equipment & Supplies

Serving The Engraving Industry Since 1985

	You are here: HOME ► CORELDRAW ► X4 NEW FEATURES


CorelDRAW'S X4 Features - Reverse Subpaths

	I missed this tip in my earlier testing of X4. But my friend Roger W from Corel shared this one with me.

		In prior versions, you could tell where the starting point for a circle was by a square node. But there was no sure way other than lasering to know what direction it would go. Normally a circle starts at top (12 o’clock) and goes clockwise. Mirror and it goes counter clockwise. But if the image was imported or had been altered, you had to laser the circle to know for sure. The new ‘pointer’ makes it easier. It also works with lines and curves. This is helpful when you are cutting out name badges.

Areas Served By The Engravers Network, Arlington, TX - Areas listed indicate VersaLaser, Vision VE-810XD and parts

Alaska (AK)
Alabama (AL)
Arkansas (AR)
Arizona (AZ)
Bahamas
California(CA)
Canada
Colorado (CO)
Connecticut (CT)
Delaware (DE)

Dubai
Florida (FL)
Georgia (GA)
Hawaii (HI)
Iowa (IA)
Idaho (ID)
Illinois (IL)
Indiana (IN)
Kansas (KS)
Kentucky (KY)

Louisiana (LA)
Massachusetts (MA)
Maryland (MD)
Maine (ME)
Mexico
Michigan (MI)
Minnesota (MN)
Missouri (MO)
Mississippi (MS)

Montana (MT)North Carolina (NC)
North Dakota (ND)
Nebraska (NE)
New Hampshire (NH)
New Jersey (NJ)
New Mexico (NM)
Nevada (NV)

New York (NY)
Ohio (OH)
Oklahoma (OK)
Oregon (OR)
Pennsylvania (PA)
Puerto Rico (PR)
Rhode Island (RI)
South Carolina (SC)
South Dakota (SD)

Tennessee (TN)
Texas (TX)
Utah (UT)
Virginia (VA)
Vermont (VT)
Washington (WA)
Wisconsin (WI)
West Virginia (WV)
Wyoming (WY)