Engravers Network-Using & Adjusting The EZ-Rider Burnishing Adapter

Phone 866-727-7256
817-261-7256
FAX 800-210-4461

Your Site For Laser & Engraving Equipment & Supplies

Serving The Engraving Industry Since 1985

	You are here: HOME ► SUPPORT ► SUPORT-VISION ► VISION TIPS► EZ-RIDER BURNISH TOOL


	Using & Adjusting Your EZ Rider Burnishing Adapter


		Using your cutter wrench, first remove the gold knob from your burnish tool. Slide your EZ-Rider burnishing Adapter on your burnishing tool ast show in #3, and tighten the set screw on the adapter. Screw your burnishing tool into your spindle, and with your cutter wrench, adjust the burnishing cutter where is about 1/4” below the nose cone as shown in #4. #5 shows the EZ-Rider with no pressure on the cutter. You can push the burnishing tool from the bottom and see the spring compress. This compression is called pre-load. It is required to keep the burnishing tool always touch the engraving surface when engraving. Depending on the type of system you have, move the spindle over the material. Using your Z-key, send the spindle down to the engraving plate. As your burnishing tool makes contact with the engraving surface, the EZ-Rider Adapter spring will start compressing. Keep sending the Z-axis down until the allen screw in the window of the EZ-Rider Adapter looks like # 5. Make sure you turn off your proximity switch if your engraver is so equipped.

AREAS SERVED BY THE ENGRAVERS NETWORK - ARLINGTON, TX - Phone 1-866-727-7256

Alaska (AK)
Alabama (AL)
Arkansas (AR)
Arizona (AZ)
California(CA)
Colorado (CO)
Connecticut (CT)
Dubai

Delaware (DE)
Florida (FL)
Georgia (GA)
Hawaii (HI)
Iowa (IA)
Idaho (ID)
Illinois (IL)
IPod USA

Indiana (IN)
Kansas (KS)
Kentucky (KY)
Louisiana (LA)
Massachusetts (MA)
Maryland (MD)
Maine (ME)

Michigan (MI)
Minnesota (MN)
Missouri (MO)
Mississippi (MS)
Montana (MT)North North Carolina (NC)
North Dakota (ND)

Nebraska (NE)
New Hampshire (NH)
New Jersery (NJ)
New Mexico (NM)
Nevada (NV)
New York (NY)
Ohio (OH)

Oklahoma (OK)
Oregon (OR)
Pennsylvannia (PA)
Rhode Island (RI)
South Carolina (SC)
South Dakota (SD)
Tennessee (TN)

Texas (TX)
Utah (UT)
Virginia (VA)
Vermont (VT)
Washington (WA)
Wisconsin (WI)
West Virginia (WV)
Wyoming (WY)

Areas listed indicate VersaLaser, Vision VE-810-XD and Dahlgren parts sales area